1, the whole board full gold process, the cost is much higher than the spray tin plate!
2, the whole board after optical short circuit, open circuit detection.
3, due to heating table and aluminum plate into one, better temperature stability.
- Resistance: 12V voltage, the resistance of 1.2 ohms
- voltage: 12V
- Size: 220mm*220mm*3mm for anet a6 a8 3d printer , 300mm * 300mm * 3mm For anet E12 3d printer /220mm*270mm*3mm for anet E10 3d printer
- the 220*220*3MM size hole spacing: 214*214mm, 270*200MM heatbed hole distance : 210*210MM the 300*300*3MM size heatbed hole distance: 275*210MM
- process: Aluminum plate
- color: black on the back, positive silver white
- thickness: 3mm
- Thermistor: the NTC 100K 1% 3950
Note:12V connection: a line then 1, another line at the same time then 2,3
220*220*3MM size heatbed Perfectly fits as a replacement for the thin Anycubic i3 Mega and Mega S hotbed!
âPay attention: 300*300*3MM heatbed cable port is on the left of corner. There is a little diffrence from the picture,
but the using condition is in good.
And about to the 220*220 size heatbed, there is new version on the surface, it cancel the warning LED guiding light. Other is the same using condition. Hope understanding!
Packaging List: 1Set(Hotbed Aluminum Heated Bed with line)